Antminer D3 19.3 GH/s X11 ASIC Dash Miner

#AntMiner #AntMinerD3 #Cryptocurrency #CryptocurrencyMiner #DashCoin #DashMiner #DashCoinMiner #ASICMiners #CryptoMiner #iCryptoMiner #Amazon

Antminer D3 19.3 GH/s X11 ASIC Dash Miner

Buy Here on Amazon: https://amzn.to/2I4A0Ol

  • Hash rate: 19.3 GH/s (Variation of ±5% is expected)
  • Power consumption: 1200W (at the wall, with Bitmain’s APW3 PSU, 93% efficiency, 25°C ambient temp)
  • Hashing algorithm: X11 (Dash and many others)
  • Power consumption figures will vary with your PSU’s efficiency, the ambient operating temperature and the accuracy of the power meter. It recommends use of the APW3++ PSU with the Antminer D3. One APW3++ PSU can not power more than one Antminer D3
  • All PCIe connectors on a hashing board need to be connected to the PSU for the hashboard to operate. Do not connect more than one PSU to the same hashing board! Separate power supply to control board: there is one additional 6pin PCIe connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the PCIE connectors are connected to power supply




Leave a Reply

Your email address will not be published. Required fields are marked *

Human Verification: In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


This site uses Akismet to reduce spam. Learn how your comment data is processed.